mru Optima 7 - Page 21

USER MANUAL OPTIMA 7
21 / 78 MRU GmbH, D-74172 Neckarsulm
In the "Measurement settings" menu you can make for example the fol-
lowing adjustments:
Temperature Unit
°C, °F
Change the unit for temperature in all
screens
Pressure Unit
Pa, hPa/Pa, hPa,
kPa/Pa, kPa,
mbar, mmH2O,
cmH2O, inH2O,
mmHg, inHg, PSI,
Change the unit for pressure in all
screens. The meaning of hPa/Pa and
kPa/Pa is that the instrument performs
a dynamic change of unit depending
on the absolute value of pressure.
Draft Unit
Pa, hPa/Pa, hPa,
kPa/Pa, kPa,
mbar, mmH2O,
cmH2O, inH2O,
mmHg, inHg, PSI,
Change the unit for pressure in all
screens. The meaning of hPa/Pa and
kPa/Pa is that the instrument performs
a dynamic change of unit depending
on the absolute value of pressure.
Core flow search
ON / OFF
Core flow search before start of each
flue gas measurement: activated or de-
activated
Combustion cal-
culation
ON / OFF
If the combustion calculation is
switched off following items will be
changed:
- no fuel types, respectively always
"Sample Gas"
- no measuring values losses, ETA,
ETAcond, Dev. point
- no measuring value CO2, except it
will be measured
- no measuring values CO/NO/,,,. in
[mg/kWh]/[mg/MJ]
- no fuel type will be shown on the
menu bar and print-out