Installation
SUPREMATouch
203
US
Printer Port (Printer, RS 232 B)
Using this port, the alarm messages can be sent to a printer so that records can be kept.
The pin assignment of the RS232B port is given in the following table (see also figure 142). Con-
nect the screening to the pin housing.
Fig. 145 RS 232B, Pin Assignment
When a signal event occurs (alarm, failure), the following information is transmitted by default in
a single line through this port to a printer:
Fig. 146 Protocol Printer, Data Structure
The results are printed each time the measurement value exceeds or falls below the alarm thresh-
old, in the event of a system failure, in the event of a successful manual reset or a signal failure.
The current status of the input is printed out in accordance with the data structure shown in
Figure 146.
NOTE: This formatting can be changed by the user! See the section Operation -> Menu -> Set-
tings -> Printer
- Connecting cable: RS 232 extension (do not use a null-modem cable!)
- RS 232 configuration: 19200 kBits/sec., 8 data bits, 1 stop bit, Parity none
Socket No. Assignment
1
2R x D
3 T x D
4
5GND
6
7
8
9
To Next Page
Loading...
