Operation of the System
SUPREMATouch
25
US
All Inputs Mode
In this mode, all the measured inputs in the system are displayed. The inputs are arranged by their
input number.
This mode is indicated with a green background for the bell symbol.
Alarming Inputs Mode
When no alarm is triggered, this mode behaves like the “All Inputs Mode”.
As soon as alarms are triggered, only the inputs in alarm are displayed, arranged by the time of
alarm triggering.
This mode is indicated with a yellow background for the bell symbol.
Failing Inputs Mode
When no point is in fail status, this mode behaves like the “All Inputs Mode”.
As soon as at least one input is in fail status, only the inputs in fail status are displayed, arranged
by their input number.
This mode is indicated with a yellow background for the sign symbol.
Power Supply Indicator
The power supply indicator gives an quick overview about the current status of the power supply
of the system.
Fig. 8 Power Supply Indicator
The 3 different power supplies are indicated with 3 different symbols. From the left to the right
these are: External, Internal, and Battery supply. The status of each supply is indicated with the
background colour. Green means "good", grey means "not configured" and yellow means "fail". A
power supply is considered as good, if the voltage is below 30V and above 21V [for battery
above 22V].
By tapping on the Power Supply Indicator, a window with information about the measuring values
of all relevant nodes appears.
To Next Page
Loading...
