EasyManuals Logo

MTS Systems FlexTest SE Service Information

Default Icon
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #212 background imageLoading...
Page #212 background image
Model 493.02 Controller Service
About Tuning
Tuning
212
If the amplitude of the feedback cannot be achieved without going
unstable, and the end levels are repeatable, simply increase the
command to achieve the desired end levels.
Monitoring the
error signal
The error signal shows similar characteristics as a feedback signal. The
error signal represents the difference between the command and
sensor feedback. The following diagrams show the error signal
characteristics for each type of waveform.
A square waveform is best suited to view the overshoot and ringing
characteristics that occur when tuning a system. Review the following
waveforms to determine the kind of characteristics that can be found
in an error signal.

Table of Contents

Other manuals for MTS Systems FlexTest SE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MTS Systems FlexTest SE and is the answer not in the manual?

MTS Systems FlexTest SE Specifications

General IconGeneral
BrandMTS Systems
ModelFlexTest SE
CategoryController
LanguageEnglish

Related product manuals