multicomp MP7505 Series - Set the Amplitude; Set the Offset; Set the High Level

MP7505 Series User Manual
11
press the Enter key to confirm the input in default unit. Press the MHz, kHz, Hz,
mHz, uHz softkeys to select the unit of the parameter. Press the Cancel softkey to
cancel the current input parameter value.
Figure 5-2: Use the numeric keypad to set the frequency
Set the amplitude
Press the Amplitude/High softkey to confirm whether the Amplitude menu item is
highlit; if not, press the Amplitude/High sofkey to switch to Amplitude. In Parameter
2 of Figure 5-1, a blinking cursor appears in the parameter value of amplitude. Turn
the rotary control to change the value directly, or use the numeric keypad to input
the desired value and choose the unit.
Set the offset
Press the Offset/Low softkey to confirm whether the Offset menu item is highlit; if
not, press the Offset/Low softkey to switch to Offset. In Parameter 3 of Figure 5-1, a
blinking cursor appears in the parameter value of offset. Turn the rotary control to
change the value directly, or use the numeric keypad to input the desired value and
choose the unit.
Set the high level
Press the Amplitude/High softkey to confirm whether the High menu item is highlit;
if not, press the Amplitude/High softkey to switch to High. In Parameter 2 of Figure
5-1, a blinking cursor appears in the parameter value of high level. Turn the rotary
control to change the value directly, or use the numeric keypad to input the desired
value and choose the unit.