MP7505 Series User Manual
System Settings
Language
(1) Press the front panel Utility function key, press the System softkey.
(2) Press the Language softkey to switch the display language.
Beeper
When the beeper is turned on, the beeper sounds when users operate the front
panel or when an error occurs.
(1) Press the front panel Utility function key, press the System softkey.
(2) Press the Beeper softkey to toggle between On or Off.
Clock Source
The generator provides an internal 10MHz clock source and can receive the external
clock source from the 10MHz/In/Out/Counter connector at the rear panel. It can
also output an internal clock source from the 10MHz/In/Out/Counter connector for
other devices.
Note:
The amplitude range of the 10MHz In/Out/Counter input signal is 1 Vpp to 3.3 Vpp.
(1) Press the front panel Utility function key, press the System softkey.
(2) Press the CLK Ref softkey to toggle between Internal and External.
Note:
The clock source defaults to the internal clock source. When an external clock source
is required, this function is switched to external. At this time, the clock output is
turned off forcibly.
Clock Output
(1) Press the front panel Utility function key, press the System softkey.
(2) Press the CLK Output softkey to toggle between On and Off.
Note:
When the clock source output is turned on, the clock source must be switched to
internal, and the counter function stops after the clock output is turned on.
To Next Page
Loading...