multicomp MP7505 Series - Burst Characteristics; Counter Specifications; Input;Output Characteristics

MP7505 Series User Manual
74
Burst Characteristics
Burst Characteristics
Waveform
Sine wave, square wave, ramp wave, pulse wave, Noise wave
(Except N Cycle) and arbitrary wave (Except DC)
Types Count (1 to 100,000 cycles), unlimited, gated
Trigger source Internal, external, manual
Carrier frequency 2mHz to BW/ 2
Trigger cycle 20ns - 500 s (Min = Cycles * Period)
Gated source External trigger
Counter Specifications
Counter Specifications
Measurement function
Frequency, period, positive pulse width, negative pulse width,
duty cycle
Frequency Range 100 mHz - 200 MHz
Frequency resolution 7 digits
Coupling method AC, DC
Voltage range and sensitivity (non-modulated signal)
DC offset range ±1.5V
DC coupling
100mHz - 100 MHz: 250 mVpp - 5 Vpp (AC+DC)
100 Hz - 200 MHz: 400 mVpp - 5 Vpp (AC+DC)
AC coupling
1Hz - 100 MHz: 250 mVpp - 5 Vpp
100 Hz - 200 MHz: 400 mVpp - 5 Vpp
Pulse width and duty cycle
measurement
1 Hz - 10 MHz (250 mVpp -5 Vpp)
Input resistance 1 MΩ
Sensitivity Can be set high, medium and low
Trigger level range ±2.5 V
Input/Output Characteristics
Input/Output Characteristics
Communication Interface
USB Host, USB Device, LAN
Channel coupling Channel copy, amplitude syn, frequency syn, align phase
External modulation input
Input frequency range DC - 100 kHz
Input level range ± 1V full scale
Input impedance 10 kΩ (typical)
External trigger input
Level TTL-compatible
Slope Rising or falling (selectable)
Pulse Width >100ns