MP7505 Series User Manual
9. Appendix
Appendix A: Accessories
1 × power cord that meets the standards of the country where you are located
1 × USB communication cable
1 × CD with communication software
1 × Quick Guide
2 × BNC/Q9 cable
Appendix B: General Care and Cleaning
General Maintenance
Do not store or leave the instrument where the liquid crystal display will be exposed to direct
sunlight for long periods of time.
Caution: To avoid any damage to the instrument or probe, do not exposed it to any sprays, liquids,
or solvents.
Cleaning
Inspect the instrument and probes as often as operating conditions require. To clean the
instrument exterior, perform the following steps:
1. Wipe the dust from the instrument and probe surface with a soft cloth. Do not make any
scuffing on the transparent LCD protection screen when clean the LCD screen.
2. Disconnect power before cleaning your instrument. Clean the instrument with a wet soft cloth
not dripping water. It is recommended to scrub with soft detergent or fresh water. To avoid
damage to the instrument or probe, do not use any corrosive chemical cleaning agent.
Warning: Before power on again for operation, it is required to confirm that the
instrument has already been dried completely, avoiding any electrical short circuit or
bodily injury resulting f
rom the moisture.
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronics
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste, but
kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area.
Made in China
LS12 2QQ
To Previous Page
Loading...