multicomp MP7505 Series - Amplitude Characteristics; Signal Characteristics

MP7505 Series User Manual
69
Ramp wave 1 μHz - 3 MHz
Noise wave (-3 dB)
MP750513 100 MHz BW
MP750512 80 MHz BW
MP750511 60 MHz BW
MP750510 35 MHz BW
Arbitrary wave 1 μHz - 15 MHz
Harmonic wave
MP750513 1 μHz - 50 MHz
MP750512 1 μHz - 40 MHz
MP750511 1 μHz - 30 MHz
MP750510 1 μHz - 17.5MHz
Frequency resolution 1 μHz or 10 significant figures
Frequency stability
±2 ppm at 25±5℃
Frequency aging rate ±1 ppm per year
Amplitude Characteristics
Amplitude Characteristics (not specifically labeled, the load defaults to 50Ω)
Output amplitude
(load defaults to 50Ω)
1mVpp to 10Vpp (≤ 25MHz)
1mVpp to 5Vpp (≤ 60MHz)
1mVpp to 2.5Vpp (≤ 100MHz)
Bandwidth flatness (relative
to 100 kHz Sine wave, 1 Vpp,
50Ω)
≤10MHz: ±0.2dB
≤60MHz: ±0.3dB
≤100MHz: ±0.5dB
Amplitude accuracy ± (1% of setting + 1 mVpp) (1kHz sine,0V offset, >10mVpp)
Amplitude resolution 0.1mVpp or 4 digits (The amplitude ≥ 1Vpp is 1mVpp)
DC offset range
(High resistance)
± (10 Vpk – Amplitude Vpp / 2)
DC offset accuracy ± (1 % of |setting| + 1 mV + amplitude Vpp * 0.5%)
Offset resolution 0.1 mVpp or 4 digits (The amplitude > 1 Vpp is 1 mVpp)
Units mVpp, Vpp, Vrms, mVrms, dBm
Output Impedance 50Ω (Typical)
Output protection
Short circuit protection, the output will be automatically turned
off when overloaded
Signal Characteristics
Signal Characteristics
Sine
Harmonic distortion
Typical (0dBm)
DC to 1MHz: <-65dBc
1MHz to 10MHz: <-60dBc
10MHz to 60MHz: <-55dBc
60MHz to 100MHz: <-50dBc
Total harmonic distortion < 0.05 %, 10 Hz to 20 kHz, 1 Vpp