multicomp MP7505 Series - Page 9

MP7505 Series User Manual
5
5
Direction key
Move the cursor of the selected parameter
6
Operation keys
Counter: Enter the counter interface
Edit: Enter the wavform edit interface
Preset: Enter the preset menu, set the reset parameter or
power-on parameter.
Utility: Set the utility function
Store: Save/load arbitrary waveform or instrument setup
Help:
To get contextual help for any front panel button or
menu softkey, press the button and then press the button for
which you need help.
7 Number
keypad
Input the parameter
8 CH2 Function
keys
CH2 button: After entering the waveform interface and
selecting the CH2 (the backlight of the button is on
), the
waveform and parameters of CH2 can be set after selection.
Blue Trigger button: CH2 manual trigger button. In sweep or
burst mode, when the trigger source is selected as “Manual”,
each press of this button will initiate a trigger.
On/Off button: Turns the output of the CH2 channel on or off.
When the output is turned on, the backlight of the button
lights up.
9
CH2 Sync
When Utility → CH1/2 Set → CH2 Sync turned on, this
terminal outputs a synchronization message that matches the
current configuration of CH2.
10
CH2 Out
Output CH2 signal
11
⇌ button
Display the inter-channel menu. You can copy the parameters
of one channel to the other, synchronize the frequency or
amplitude, and align the phase of two channel signals.
12
CH1 Out
Output CH1 signal
13
CH1 Sync
When Utility → CH1/2 Set → CH1 Sync
turned on, this
terminal outputs a synchronization message that matches the
current configuration of CH1.
14
CH1 Function
keys
CH1 button: After e
ntering the waveform interface and
selecting the CH1 (the backlight of the button is on
), the
waveform and parameters of CH1 can be set after selection.