Self-moving compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 2 Series
Instruction manual (Translation of original instructions)
CM170003EN - 16.02.17 - 04 (11.07.18)
39/70
MultiOne SRL
8.3.2 Starting up
DANGER
BEFORE PROCEEDING TO STARTING OF THE MACHINE MAKE SURE THAT, IN THE RADIUS OF TEN METRES THERE ARE NO
THINGS, ANIMALS OR PEOPLE WHOSE SAFETY MAY BE AFFECTED ACCIDENTALLY.
WARNING
BEFORE STARTING THE MACHINE IT IS COMPULSORY TO HAVE CARRIED OUT ALL THE CONTROLS (SEE PAR. 8.2).
BEFORE STARTING THE MACHINE IT IS COMPULSORY TO CHECK ALL THE COMMANDS ARE IN NEUTRAL POSITION AND
THAT THE PARKING BRAKE WAS INSERTED, PARTICULARLY CHECK THAT THE HYDRAULIC FLOW CONTROL PEDAL OF QUICK
CONNECTIONS (FIG. 18 - REF. 1) IS IN “CENTRAL” POSITION (ATTACHMENT OFF).
BEFORE STARTING THE MACHINE MAKE SURE THE PLANNED MAINTENANCE WAS CARRIED OUT, PARTICULARLY CLEANING OF
THE MACHINE. MAKE SURE THERE ARE NO OBJECTS OR MATERIAL THAT PREVENT THE PROPER DRIVE CONTROL.
To start a cold engine proceed as follows:
1) Place the accelerator full forward (choke on) (FIG. 19 - Ref. 1).
2) Turn the key (FIG. 19 - Ref. 2) in Pos. “2” for two seconds, if the engine does not start, release the key and start from step 1).
3) When the engine is started, lower gradually the starter control until the engine runs smoothly.
To start a hot engine proceed af follows:
1) Place the accelerator in the middle position.
2) Turn the key (FIG. 19 - Ref. 2) in Pos. “2” for two seconds, if the engine does not start, release the key and start from step 1).
ATTENTION
BEFORE USING THE MACHINE, WE ADVISE TO EFFECTUATE SOME “USING TESTS” TO ACQUIRE A GRADUAL MASTERY OF THE
FEATURES OF THE MACHINE.
1
22
2
22
3
221
222
FIG. 18 FIG. 19
8.3.3 Handling
To move the machine proceed as follows:
1) Turn on the machine (see par. 8.3.2).
2) Release the parking brake lever (see par. 8.3.8).
3) Increase engine rpm by actuating the accelerator control lever.
4) Press the proportional pedal relative to the direction of “Forward” (FIG. 18 - Ref. 2) o “Reverse” (FIG. 18 - Ref. 3).
5) Using the steering wheel set the direction of travel.
OPERATION -8
To Next Page
Loading...
Need help?
General
