Self-moving compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 2 Series
Instruction manual (Translation of original instructions)
CM170003EN - 16.02.17 - 04 (11.07.18)
53/70
MultiOne SRL
9.7 Machine maintenance
9.7.1 Cleaning of the machine
The cleaning of the machine is essential to ensure reliability and efficiency. The accumulation of dust and dirt can cause malfunctions
and damages.
At the end of the workday, especially if the machine is being used in dusty conditions, proceed to clean:
• The cooling radiator of the hydraulic system should be cleaned using a jet of compressed air at low pressure and a soft brush
to remove dirt.
• The outer surfaces of the machine can be washed with a pressure washer and a clean cloth.
• Clean the inside of the cabin with appropriate mild detergent and a clean cloth.
WARNING
IT IS FORBIDDEN TO USE HIGH PRESSURE WATER JETS.
9.7.2 Check tyres pressure
Inflate the tyres to the correct pressure ensures reliability and more safety when using the machine. Before inflating check the
integrity of the tyre and wheel, if they are damaged, replace them. The inflation pressure is indicated in par. 11.5.
DANGER
NEVER EXCEED THE VALUE OF INFLATION PRESSURE RECOMMENDED ACCORDING TO THE TYRE MODEL.
9.7.3 Check structural integrity and tightening bolts
• ROPS and FOPS: verify that the structure is not deformed, that it doesn’t have any cracks, rust or parts without paint. Verify that
the attachment points and related bolts are intact.
• Safety belts: check the attachment points and relative bolts are intact and the coupling system is not damaged.
• Bolts wheels: check that the bolts are tightened.
9.7.4 Battery check
WARNING
THE BATTERY ACID IS HIGHLY POISONOUS AND CAN CAUSE BURNS AND IRRITATION. ALWAYS WEAR PERSONAL PROTECTIVE
ATTACHMENT (GLOVES, GOGGLES, PROTECTIVE SUIT).
The battery is located inside the engine compartment on the right side (FIG. 32 - Ref. 1).
1) Put the machine in “safety state” (see par. 9.2).
2) Open the engine cover (see par. 9.4).
3) Remove the key of the battery switches.
4) Checks:
• The battery is intact and not leaking.
• Check power cable connections for signs of leaking, corrosion, or damage.
• Check to make sure the battery is securely attached to the machine frame.
MAINTENANCE -9
To Next Page
Loading...
Need help?
General
