Self-moving compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 2 Series
Instruction manual (Translation of original instructions)
CM170003EN - 16.02.17 - 04 (11.07.18)
57/70
MultiOne SRL
9.7.8 Hydraulic oil change
To change the hydraulic oil proceed as follows:
1) Put the machine in “safety state” (see par. 9.2)..
2) Place under the hydraulic oil tank a suitable sized container with a capacity of at least 30 l.
3) Remove the hydraulic tank drain plug (FIG. 36 - Ref. 1), located under the machine near the right front wheel, and drain all
hydraulic oil from the machine into the container.
4) When all of the hydraulic fluid has drained out of the tank, reinstall and secure the drain plug. Make sure to inspect the drain plug
O-ring (FIG. 36 - Ref. 2) for signs of wear or damage. Replace the O-ring if any signs of damage are noted.
5) Change the oil filter (see par. 9.7.6).
6) Remove the cap of hydraulic oil tank (see par. 9.7.5).
7) Refill the hydraulic oil tank with recommended hydraulic oil - 0280 PAKELO HYDRAULIC EP AL ISO 46.
8) Check the hydraulic oil level (see par. 9.7.5).
9) Turn on the machine (see par. 8.3.2) for a few of minutes, in this way the oil flows inside the circuit oil.
10) Turn off the machine (see par. 8.3.7).
11) Check again the hydraulic oil level (see par. 9.7.5).
ATTENTION
THE USED OIL AND FILTER MUST BE DISPOSED OF IN ACCORDANCE TO THE LAWS IN FORCE IN THE COUNTRY WHERE THE
MACHINE IS USED.
FIG. 36
1
2
MAINTENANCE -9
To Next Page
Loading...
Need help?
General
