Self-moving compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 2 Series
Instruction manual (Translation of original instructions)
CM170003EN - 16.02.17 - 04 (11.07.18)
47/70
MultiOne SRL
FIG. 26 FIG. 27
8.4 Functions / exceptional situations
8.4.1 Instability of the machine
It may happen that by performing a curve at high speed or by lifting a heavy load the machine is to be in a state of instability.
To avoid this situation proceed as follows:
1) Steer the machine only at low speed and with the load as close as possible to the ground.
2) Do not lift heavy loads by buckets or other attachment for lifting (see par. 4.5.2).
8.4.2 Overpressure in the hydraulic circuit
The machine is equipped with a system of hydraulic valves that limit the oil pressure within the circuit to avoid any damage.
In particular difficulty running it may happen to hear a hissing sound. This indicates that the valves were brought into service. If the
condition of effort should go on and this may result in damage so you will need to decrease the stress for the machine by reducing
the speed of work and/or the number of the engine rpm.
8.4.3 Loss of control
In case the amount of oil inside the hydraulic circuit decreases considerably due to a fault with relative loss it may happen that the
machine enters into neutral and loses the effect of engine brake given by the hydraulic circuit. In this condition the control of the
machine can be compromised. To avoid this situation proceed as follows:
1) Before any starting check the presence of possible loss.
2) Check the hydraulic oil level and if necessary top up (see chap. 9).
DANGER
IN CASE OF EMERGENCY SITUATION OPERATE THE PARKING BRAKE TO STOP THE MACHINE.
HYDRAULIC OIL UNDER PRESSURE CAN PENETRATE BODY TISSUE CAUSING SERIOUS INJURY AND POSSIBLE DEATH. WHEN
TROUBLESHOOTING A HYDRAULIC SYSTEM FOR LEAKS, ALWAYS USE CARDBOARD OR WOOD AS A DETECTOR. DO NOT USE
YOUR BARE HANDS.
OPERATION -8
To Next Page
Loading...
Need help?
General
