Self-moving compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 2 Series
MultiOne SRL
Instruction manual (Translation of original instructions)
CM170003EN - 16.02.17 - 04 (11.07.18)
38/70
8.2 Checks before ignition
DANGER
BEFORE USING THE MACHINE IT IS COMPULSORY THAT AUTHORISED OPERATORS READ AND UNDERSTAND ALL PARTS OF
THIS MANUAL.
BEFORE TURNING ON THE MACHINE THE OPERATOR MUST ALWAYS CHECK THE HYDRAULIC OIL LEVEL (SEE PAR. 8.4.3).
WARNING
IT IS COMPULSORY, BEFORE STARTING THE MACHINE, TO EXECUTE THE FOLLOWING CONTROLS.
Ref. Operations
1 Make sure the machine is undamaged in all its parts.
2 Make sure the safety systems are intact (belt, ROPS, etc.).
3 Check the fuel level on the gauge panel (see par. 4.3.1).
4 Check the oil engine level (see chap. 9).
5 Check the oil level of the hydraulic circuit (see chap. 9).
6 Make sure all controls are in neutral position.
7 Make sure the accelerator is POS. “Turtle” (see par. 4.3.1).
8 Make sure the parking brake is on (see par. 8.3.8).
9 Make sure it was carried out routine maintenance (see par. 9.5).
TAB. 19
8.3 Normal operations
8.3.1 Procedure to get on to the operating position of the machine
WARNING
YOU MUST KEEP THE FOOTBOARDS CLEAN FROM DEBRIS AND MUD.
To get on the machine proceed as follows:
1) Hold with the left hand to the front upright of the roof.
2) Place your right foot on the left footboard where there is the non-slip strip.
3) Rise and sit on the seat.
4) Place your feet on the respective footboards at non-slip strips.
5) Fasten your safety belt.
8.3.1.1 Correct posture of use
The optimum posture that the operator in charge must assume for a correct use of all the commands is as follows:
• Sitting on the seat with his back against the backrest and the seat belt fastened.
• Facing towards the direction of travel.
• Left hand on the steering wheel.
• Right hand free to operate all other commands.
• Left foot resting on the footboard in correspondence with the non-slip strip and ready to operate the hydraulic ow pedal of quick
connections.
• Right foot resting on the footboard in correspondence with the non-slip strip ready to operate the proportional forward and reverse
pedal.
8- OPERATION