Setting the Contrast
Set the contrast to scan with according to the document.
•
Lightest: Select to scan with the lightest contrast.
•
Lighter: Select to scan with a contrast lighter than the standard contrast.
•
Normal: Select to scan with the normal contrast.
•
Darker: Select to scan with a contrast darker than the standard contrast.
•
Darkest: Select to scan with the darkest contrast.
Load the document, and press <Fax>.
1
Press [Contrast].
2
If [Contrast] is not displayed, press [Advanced] and then select [Contrast].
Select the desired contrast, and press [Enter].
3
Lightest
Darker
Lighter
Normal
Darkest
Specify the destination, and press <Start>.
4
For details on specifying the destination, refer to “• Selecting from the Address Book”. (See
page 5-2.)
If you loaded the document in the ADF, this concludes the procedure.•
If you loaded the document on the document glass, load the next document, and press •
[Next Doc]. Press [Tx Start] to start transmission.
To Next Page
Loading...
Need help?
General
