Specify the destination, and press <Start>.
4
For details on the procedure, refer to “• Basic Scanning”. (See page 1-2.)
If you loaded the document in the ADF, this concludes the procedure.•
If you loaded the document on the document glass, load the next document, and press •
[Next Doc]. To finish scanning, press [Complete].
Setting the Scan Format
You can set whether to scan the document in color or monochrome.
Load the document, and press <Scan>.
1
For details on loading documents, refer to Chapter 1, “Loading Documents” in the User’s
Guide.
Press [Color].
2
Scan format switches between “Mono” and “Color” each time you press [Color].•
If [Color] is not displayed, press [Advanced] and then select [Color].•
Specify the destination, and press <Start>.
3
For details on the procedure, refer to “• Basic Scanning”. (See page 1-2.)
If you loaded the document in the ADF, this concludes the procedure.•
If you loaded the document on the document glass, load the next document, and press •
[Next Doc]. To finish scanning, press [Complete].
To Next Page
Loading...
Need help?
General
