1
Basic Scan Functions
Basic Scan Settings 1-21
Select the desired document type, and press [Enter].
3
Specify the destination, and press <Start>.
4
For details on the procedure, refer to “• Basic Scanning”. (See page 1-2.)
If you loaded the document in the ADF, this concludes the procedure.•
If you loaded the document on the document glass, load the next document, and press •
[Next Doc]. To finish scanning, press [Complete].
Setting the Contrast
Set the contrast to scan with according to the document.
Lightest: Select to scan with the lightest contrast.
Lighter: Select to scan with a contrast between the normal contrast and the lightest contrast.
Normal: Select to scan with the normal contrast.
Darker: Select to scan with a contrast between the normal contrast and the darkest contrast.
Darkest: Select to scan with the darkest contrast.
Load the document, and press <Scan>.
1
For details on loading documents, refer to Chapter 1, “Loading Documents” in the
User’s Guide.
To Next Page
Loading...
Need help?
General
