5.12.3 Cutter Endurance Menu P.5-74
5.12 Endurance Running Menu VJ1324E-M-02
5.12.3 Cutter Endurance Menu
Performs media cutting by the designated cut method for the designated number of times.
T I P
• If the number of endurance running cycles is set to -1, Cutter continuously repeats endurance
running until it is canceled from Operation panel.
• The maximum counter value for endurance running cycles is 99999999 (up to 8-digit number).
If the number of cycles exceeds the maximum value, the counter displays 99999999.
[Enter]
[Enter]
[Enter]
[Enter]
Completing endurance or [Cancel]
㧯㨡㨠㧦㧿㨕㨚㨓㨘㨑㧯㨡㨠㧞㨟㨠㨑㨜㨟
㧸㨕㨒㨑㧟㧦㧯㨡㨠㨠㨑㨞
㧸㨕㨒㨑㧯㨛㨡㨚㨠㧦ޓޓޓޓޓޓޓޓ㧡㧜
㧯㨛㨡㨚㨠㧦ޓޓޓޓޓޓޓޓޓޓޓޓ㧝㧜ޓ
㧱㨚㨐㧦ޓޓޓޓޓޓޓޓޓޓޓޓޓޓ㧡㧜
㧼㨍㨓㨑ޓ㧿㨕㨦㨑㧦ޓޓޓޓޓ㧡㧜㨙㨙
[Enter]
ޓor
[Cancel]
=?MG[
= ?MG[
㨀㨕㨙㨑ޓ㨃㨍㨕㨠㧦ޓޓޓޓޓޓޓ㧠㧜㨟
50mm㨪3000mm
Confirming Waiting time
㧯㨔㨑㨏㨗㧥㧦㧱㨚㨐㨡㨞㨍㨚㨏㨑
㧯㨡㨠㧦㧿㨕㨚㨓㨘㨑㧯㨡㨠㧟㨟㨠㨑㨜㨟
㧯㨡㨠㧦㧰㨛㨡㨎㨘㨑㧯㨡㨠㧞㨟㨠㨑㨜㨟
㧯㨡㨠㧦㧰㨛㨡㨎㨘㨑㧯㨡㨠㧟㨟㨠㨑㨜㨟
Change the value (unit to count) by pressing
[setting/value+] or [setting/value-] key.
Endurance Count
Performing endurance
To Next Page
Loading...
