2.3 Troubleshooting Without Error Messages VJ1324E-M-02
2.3.4 Noise Problems P.2-59
5
Abnormal noise is heard
during media cut.
1. Is cutter cap on upper side of cutter set securely? Remount cutter cap.
"3.7.15 Replacing Cutter Solenoid
Assy, Cutter Solenoid Spring Assy" p.3-
133
2. Does cutter move up and down smoothly? • Remount cutter spring.
• Remove foreign objects, if any.
3. Are there any foreign objects attached on cutter groove
and surface of Platen?
Remove foreign objects.
―
4. Are Platen cutter groove and cutter blade parallel? Perform adjustment.
"4.8 Cutter Holder Height
Adjustment" p.4-15
5. Cutter may be defective. Replace cutter.
"3.7.15 Replacing Cutter Solenoid
Assy, Cutter Solenoid Spring Assy" p.3-
133
6. CR board Assy may be defective. Replace CR board Assy .
"3.7.4 Replacing CR Board Assy"
p.3-101
7. CR_FFC may be damaged. Replace CR_FFC.
"3.11.3 Replacing CR_FFC" p.3-
154
8. Power board Assy may be defective. Replace power board Assy .
"3.4.10 Replacing Power Board
Assy" p.3-50
Table 2-9 Symptoms, Check Items, and Actions for Noise Problems (Continued)
No. Symptoms Check Item Action Reference
To Next Page
Loading...
