Handling the printer VJ-1324 OPERATION MANUAL
138 4.4 Operating from the operation panel
4.4.4 Cutting media manually
This section explains how to cut the roll media manually.
CAUTION
• Right after printing, the media guide becomes very hot.
Allow the media guide to cool down before the next operation.
Follow the procedure below to cut the roll media.
1. Verify the following regarding the operational condition of the product.
• Printing or other operations are not in progress.
• The operation panel display is Normal.
2. To change the position to cut the roll media, refer to "
4.4.1 Feeding media" and advance the roll
media to the desired cut position.
3. Place a razor blade on the media cut groove on the media guide, and cut the roll media.
CAUTION
• Pay attention to the following points when cutting roll media.
Mishandling the razor blade may cause a cut on your finger or hand.
• When you hold media, do not place your finger on the media cut groove.
• Move the razor blade along the media cut groove.
• The procedure for cutting the roll media is complete.
No. Name
1 Media guide
2 Media cut groove
3 Razor blade
2
1
3
To Next Page
Loading...
Need help?
General