Troubleshooting VJ-1324 OPERATION MANUAL
248 7.1 Malfunctions and failures
7.1.3 Media-related troubleshooting
(1) The media slips or is torn during initialization
NOTE
• If the media is jammed or torn, remove it according to "7.3 The media is jammed".
2 Are the network settings configured
correctly?
Configure the network settings correctly.
5.1.22 IP
Address menu to
5.1.24 Gateway
menu
3 Match the printer’s network settings with the
computer side environment.
Match this product’s network settings with the
computer side environment.
3.7.1 System
requirements
4 Does the Power lamp on the operation panel
turn on after sending printing data from the
computer?
If the Power lamp does not turn on, contact the
computer manufacturer.
—
No. Possible cause Remedy Reference
1 Are you using the recommended media? Use the recommended media.
4.2.1 Media
type
2 Is the loading position of the media correct? Set the media correctly.
3.4 Loading
media
3 Is the scroller set correctly? Set the scroller correctly.
3.4.1 Loading
roll media
4 Are there any foreign materials such as paper
attached to the pressurizing roller?
Clean the pressurizing roller.
6.2.2 Cleaning
the inside of the
printer
5 Is the printer being used in an environment
other than the one specified, such as in direct
sunlight?
Only use the printer in an environment that is
specified for use.
Installation
manual
6 Are you using folded, torn or rolled media? Replace the media.
4.2.2 Cautions
on handling media
7 Does the media bend? Use the recommended media.
When using media other than the dedicated
one, set the Vacuum Fan menu.
4.2.1 Media
type
5.1.1.1.8
Vacuum Fan menu
No. Possible cause Remedy Reference
To Next Page
Loading...
Need help?
General