VJ-1324 OPERATION MANUAL Before using
3.6 Adjust Print 111
3.6.2.3.2 Each Adjust Patterns
Select and print one of the adjust patterns A to F and register the set value.
Follow the procedures below to adjust "Pattern A" only.
1. Display the Custom Adjust Print menu on the operation panel in the same way as in step 2 of
"
3.6.2.1 Custom Confirmation Pattern".
2. Press the [+] key or [-] key to select "Adj.4: Fine PatternA".
3. Press the [Enter] key on the operation panel.
• "Warming Up", and then "Warming Up Skip -> E" are displayed.
NOTE
• To start printing during warming up, press the [Enter] key while "Warming Up Skip -> E" is
displayed.
4.4.7 Start Printing during Warm up
• An Adjust print pattern for print quality adjustment is printed after warming up.
• Regarding adjust print patterns, the same patterns are printed repeatedly on both edges and the
center of the paper.
To Next Page
Loading...
Need help?
General