VJ-1324 OPERATION MANUAL Maintenance
6.2 Cleaning the printer 227
NOTE
• If you fail to remove blurs or incompleteness of printing in one Head cleaning, perform strong
cleaning.
• If blurs or lacking parts in printed media do not disappear with several times of Head cleaning, refer
to "
7 Troubleshooting", and take appropriate measures.
6.2.4 Cleaning the cleaning wiper
This section describes how to clean the cleaning wiper.
(1) Time for cleaning
Once a week, or when blurs or lacking parts appear on printed media after Head cleaning.
(2) Cleaning procedures
Follow the procedure below to clean the cleaning wiper.
NOTE
• Use the cleaning stick to clean the cleaning wiper.
For details of the cleaning stick, refer to "
8.3 Options/Supply list".
1. If the printer is turned ON, make sure the following.
• Printing or other operations are not in progress.
• The operation panel display is Normal.
2. Display the CR Maintenance menu on the operation panel.
a. Press the [Menu] key on the operation panel.
• "Menu1: Setup>" is displayed on the operation panel.
To Next Page
Loading...
Need help?
General