VJ-1324 OPERATION MANUAL Panel setup menu
5.1 Setup menu 169
(5) Micro Adj.Change menu
Sets up Micro Adjustment Change.
5.1.1.1.5 Pre-heater menu
Sets the temperature of the pre-heater.
Set to curb a rapid temperature change at the printing portion by pre-heating the media before printing.
NOTE
• The set temperature of the pre-heater differs depending on the media.
For the set temperatures of the pre-heater, refer to "recommended media list".
Setup item Setting Description
Micro Adj.Change -5.00% to <0.00> to 5.00% Sets up Micro Adjustment Change.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup item Setting Description
Pre heater Off / <30 °C> to 50 °C Sets the temperature of the pre-heater.
1.Roll media
2.Pre heater
3.Print head
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.1.1 User Type menu
23
1
To Next Page
Loading...
Need help?
General