Panel setup menu VJ-1324 OPERATION MANUAL
178 5.1 Setup menu
(2) MediaWidth menu
5.1.6 Output Mode menu
Sets the media operation after printing.
NOTE
• When the take-up unit is not installed, do not set Output mode to "Take-up". By doing so, the
product will be unable to function properly.
• When the Output Mode menu is set to "Take-up", the setting for the Prev. Stick menu is disabled.
5.1.9 Prev. Stick menu
5.1.6.1 Ink Drying Time Menu
This menu is used to set ink drying time.
Setup item Setting Description
MediaWidth **** mm Display the media width that is detected while initializing.
— • [Cancel] key: shifts to the previous menu.
5.1 Setup menu
Setup item Setting Description
Output mode <Off> Set when not cutting the media automatically after printing.
(Set it to "Off" even when cutting the media manually.)
Take-up Set when using the take-up unit.
(The media will not be cut after printing.)
Auto Cut Set when cutting the media automatically.
5.1.7 Method of Cut menu
— • [Enter] key: saves the setting and shifts to the sub menu.
5.1.6.1 Ink Drying Time Menu
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup Item Setting Description
Ink drying time <0sec> to 60min Set the ink drying time.
— • [Enter] key: Saves the set value and shifts to the previous
menu.
• [Cancel] key: Cancels the setting and shifts to the previous
menu.
5.1.6 Output Mode menu
To Next Page
Loading...
Need help?
General