VJ-1324 OPERATION MANUAL Before using
3.5 Test print 73
Follow the procedure below to perform the Color Verify
1. Turn ON the printer and load the roll media.
3.4.2 Setting Roll Media
2. Set the user type setting.
3.4.3 Setting the User Type Setting
3. Check the temperature setting of each heater.
• Preset Pre heater temperature
5.1.1.1.5 Pre-heater menu
• Preset platen-heater temperature
5.1.1.1.6 Platen heater menu
• Preset dryer temperature
5.1.1.1.7 Dryer menu
4. Display the Test Print menu on the operation panel.
a. Press the [Menu] key on the operation panel.
• "Menu1: Setup>" is displayed on the operation panel.
• The operation panel shifts to the Setup menu display.
b. Press the [+] key or [–] key to select "Menu2: Test Print>".
To Next Page
Loading...
Need help?
General