VJ-1324 OPERATION MANUAL Before using
3.6 Adjust Print 97
4. Check the both ends and the center of the print result that printed with Adjust pattern, and select the
number from 1 to 7 that is not out of alignment.
• "6" is selected in the next printing sample.
NOTE
• "4" is the current setting value.
5. "Pattern *: 4" (* indicates a pattern name as shown below) is displayed on the operation panel.
• The pattern name (*) differs depending on the set print mode.
The print modes and their pattern names are as follows.
6. Press the [+] key or [–] key to enter the number that you selected in Step 4.
NOTE
• When you press the [Cancel] key, the input operation is not executed and "Adj.3: Fine Pattern" is
displayed on the operation panel.
PrintMode PatternName
Quality 1, 2 C
Quality 3, 4 B
Graphics 1, 2 E
Graphics 3, 4 D
Banner 1, 2 A
Banner 3, 4 A
To Next Page
Loading...
Need help?
General