14 - 16
Fuel Injection System
9.612.0.006.7160 - 05/04
Inspection
Perform a visual analysis on the cooler to check for
any irregularity. Change it if necessary.
Check cooler drain plug for leakages.
Change it if necessary.
Tighten with 10 ± 1.5 Nm.
Visually check the condition of the nipples. If
necessary, change them. Apply the specified torque.
The cooler has a drain plug. If the change is necessary,
first apply liquid gasket and then apply the specified
torque.
If problems in injection system are caused by the
ECM, the component, under no circumstances, must
not be open to check or repair. The violation of the
module cancels the warranty of the component and,
consequently, the total warranty of the engine.
To Next Page
Loading...
Need help?
General
