Camshaft
6 - 5
9.612.0.006.7160 - 05/04
Pre-Assembly Inspections and
Measurements
Visually check the tappets. Check if there are marks
of excessive waste on the contact area with the cams
of the camshaft.
Attention
• During its operation the tappets perform a rotating movement, responsible for a uniform
distribution of the force, uniforming the waste. It must not have waste on only one area.
Visually check tappet lubrication holes.
Attention
• The lubrication holes of the tappets cannot be obstructed.
To Next Page
Loading...
Need help?
General
