MWM Acteon User Manual

215 pages

To Next Page

To Previous Page

10 - 6

Flywheel and Flywheel Housing

9.612.0.006.7160 - 05/04

With the engine locked assembly the flywheel. Tighten

the crankshaft fixation bolts according to the

specification.

Inspections After Assembly

After the flywheel installation, measure the

concentricity of the fitting of the shaft pilot in relation

to the housing.

Maximum concentricity = 0.2 mm

Install the rear seal with the special tool MWM nr.

9.610.0.690.020.6.

Questions and Answers:

Need help?

Do you have a question about the MWM Acteon and is the answer not in the manual?

General