MWM Acteon User Manual

215 pages

To Next Page

To Previous Page

Cylinder heads

8 - 11

9.612.0.006.7160 - 05/04

Pre-Assembly Inspections and

Measurements

Visually check cylinder heads for leaks.

Check push rods. The push rods ends must not be

loosen or cracked. Check for excessive waste and if

the lubrication hole is not obstructed. Check if the

push rods are not warped.

Cylinder heads surfaces must never be machined.

Questions and Answers:

Need help?

Do you have a question about the MWM Acteon and is the answer not in the manual?

General