6.10 The Marker function
Narda IDA-3106 111
To use the Delta function:
The Marker sub-menu is active.
1. Press the Marker softkey until Marker: Delta B-A is shown.
2. Press the Active Marker softkey to select marker A.
3. Press the Active Trace softkey to select a trace type / detector for
Marker A.
4. Move Marker A to the desired position (either manually or using the
Peak functions).
5. Press the Active Marker softkey to select marker B.
6. Select a trace type / detector for Marker B.
The difference determined depends on the trace type / detector selected for
Marker A and Marker B:
• Same trace type / detector for Marker A and Marker B:
The difference between the measured values of one trace type/detector
at two different frequencies is determined.
• Different trace types / detectors for Marker A and Marker B:
The difference in the measured values between the two trace types /
detectors at one frequency is determined.
7. Move Marker B to the desired position (either manually or using the
Peak functions).
The selected frequencies and the corresponding measured values
along with the difference are displayed in the upper status bar.
To Next Page
Loading...
