NARDA IDA - Page 215

11.3 Selecting measurement parameters
Narda IDA-3106 207
 A spectrogram view is selected.
1. Press the Display softkey.
2. Press the FFT Overlap softkey, select an item using the rotary control
knob, and press OK to set the selection.
11.3.4 Display time domain (trigger time point)
I⁄Q Analyzer • View: Sgram Zoom
 HiRes Spectrogram Zoom view is selected.
1. Press the Display softkey.
2. Press the Goto Trigger Time softkey to display the time domain with the
trigger time point.
NOTE: At the same time, the marker is set to the trigger time point in the Marker
menu. It is always set to the lowest spectrogram line in Free Run trigger
mode.