NARDA IDA - Page 234

13 Measurement Data Memory
226 IDA-3106 Narda
13.7 Saving measured values automatically
You can also save results automatically in the data memory instead of
pressing the SAVE key each time you want to save a result. There are two
memory functions for this purpose:
• Event triggered saving
Saving of results starts as soon as the trigger condition is met and a
measurement is triggered. Automatic storing controlled by trigger events
is only possible in Time Domain (Scope) and I⁄Q Analyzer modes.
• Timer controlled saving
Storing of data is controlled by a start time and a duration. Timer-
controlled storing is only possible in Spectrum, Level Meter and
Multi-Channel Power modes.
NOTE: The internal memory of the IDA-3106 has the capacity to store large
quantities of data. However, reading out a large number of data sets from
the instrument to a PC can take a long time. Try not to fill the data memory
too much, and carry out regular data maintenance.
13.7.1 Event triggered storing of measured values
(Scope)
NOTE: Automatic storing of measured values controlled by trigger events is only
possible in Time Domain (Scope) and I⁄Q Analyzer mode. You can find
information about this under Saving measured values automatically on
page 195.
13.7.2 Time controlled storing of measured values
(Time Controlled Storing)
Main Menu • Memory Menu • Time Controlled Storing
NOTE: Timer-controlled storing is only possible in Spectrum, Level Meter and
Multi-Channel Power modes.
NOTE: Time controlled storing in Scope mode is started from the operating mode
itself and not from the Main menu. You can find information about this under
Using the trigger function on page 192.