5.2 Displaying and editing system settings
Narda IDA-3106 75
Resetting all device settings
You can reset the system settings (except those mentioned under Resetting
the system settings) and the measurement settings with this function. This
function is available in all menus.
To reset all device settings:
Any menu is open.
1. Press and hold down the ESC key for 3 seconds.
2. Press the OK key.
– or –
The Main Menu • Settings • Service Menu is open.
1. Press the Factory Settings softkey.
2. Press the OK key.
5.2.7 Performing device diagnosis
Main Menu • Settings • Service Menu
This menu allows you to test the function of the LCD monitor, display certain
instrument data and reset the instrument to the factory settings.
Press the Service Menu softkey.
The Service Menu is displayed.
To check the display:
Press the Display Test softkey.
The basic colors red, blue and green are displayed in turn.
The test stops after three cycles.
Press the ESC key to end the test immediately.
To display the device diagnostics:
Press the Device Diag softkey.
A list of some basic data is displayed.
NOTE: The displayed data is intended primarily for servicing purposes.
Table 15: Description of Device Diagnostics list
Information Description
Mainboard Temperature Temperature of main circuit board
RF-Board Temperature Temperature of RF circuit board
RF-Board Hardware Version RF board hardware version
To Next Page
Loading...
