Native Instruments MASCHINE MK3 Getting Started

Similarly to changing the Pattern Length, changing the Step Grid resolution can result in a
greater amount of steps in your Pattern than what your sixteen pads can represent. In that
case, as described earlier, you can use the Page buttons to display the previous/next sixteen
steps of your Pattern.
8.2.2 Adjusting the Step Grid on Your Controller
On your controller, to change the Step Grid resolution, do the following:
1. Press SHIFT + FOLLOW (Grid).
2. Press Button 4 to select STEP and access the Step Grid’s resolution setting.
Now the pads represent the various resolution values available. The available resolutions
are indicated on the right display. The selected resolution is also highlighted on the right
display and the corresponding pad is lit.
3. Press any pad to select another value.
→ The Step Grid uses the new resolution value.
8.3 Saving Your Project
Again, it is recommended to regularly save your work. You can then open another Project or
close MASCHINE and take a break. Your tutorial Project will be recalled as it was the next time
you open it.
To save your Project in the software:
Creating Beats with the Step Sequencer
Adjusting the Step Grid
MASCHINE - Getting Started - 128

Native Instruments MASCHINE MK3 Specifications

General

Brand	Native Instruments
Model	MASCHINE MK3
Category	Recording Equipment
Language	English