Native Instruments MASCHINE MK3 Getting Started

You will find two examples using a recording setup with step-by-step instructions on how
to route external audio to a particular Sound of your MASCHINE Project in section
↑11.3.2, Using an External Sound Source and ↑11.4.1, How to Sample.
You can use the described setups with MASCHINE as well as with any other music soft-
ware running on your computer. For the audio device configuration required on the soft-
ware side, see ↑2.2.1, Using Your Controller as Audio Device in the MASCHINE Soft-
ware or ↑2.2.2, Selecting the MASCHINE Controller as Audio Device in Other Music
Software, respectively.
2.3.3.1 Connecting a Dynamic Microphone
This example shows a setup with both a pair of active speakers (see ↑2.3.1, Connecting Active
Monitor Speakers) and a pair of headphones (see ↑2.3.2, Connecting Headphones) with an ex-
tra dynamic microphone, e.g., for working with voice.
MASCHINE setup with a dynamic microphone.
Setting Up MASCHINE
Setup Examples
MASCHINE - Getting Started - 27

Native Instruments MASCHINE MK3 Specifications

General

Encoders	8 touch-sensitive knobs
Audio Interface	24-bit / 96 kHz
MIDI I/O	1 x MIDI In, 1 x MIDI Out
USB	USB 2.0
Pads	16 x Multi-color Pads, Velocity-Sensitive, Aftertouch
Display	2 full-color screens
Outputs	1/4" TRS Line Outputs, Stereo Headphone Output
Software	Maschine Software
Power Supply	USB bus-powered
Dimensions	320 x 301 x 41 mm
Weight	2.2 kg
System Requirements	Intel Core i5, 4 GB RAM
Inputs	1 x 1/4" TRS Mic Input, 2 x 1/4" TRS Line Inputs