2 Setting Up MASCHINE
This chapter provides basic setup information and guides you through the process of integrat-
ing MASCHINE into your studio.
The MASCHINE software is installed both as a stand-alons application as well as a VST, Audio
Unit, and AAX plug-in.
The MASCHINE stand-alone application must be opened once before using the plug-in
within your DAW for the first time, after every upgrade, and after installing new MA-
SCHINE EXPANSIONS.
The MASCHINE stand-alone application directly communicates with your audio and MIDI in-
terfaces, which you can configure in the MASCHINE Preferences as described later in this
chapter (see ↑2.2, Basic Audio Configuration). When MASCHINE is used as a plug-in within a
host, the communication with your audio and MIDI interfaces is managed by the host.
For details about the audio and MIDI configuration of your host, and how to load plug-
ins, please refer to its documentation.
2.1 Connecting the Controller to the Computer
To connect the MASCHINE controller to your computer:
1. Attach the “device end” of the included USB cable to the USB socket on the rear panel
of the controller.
Setting Up MASCHINE
Connecting the Controller to the Computer
MASCHINE - Getting Started - 17
To Next Page
Loading...
