2. Attach the “computer end” of the USB cable to an available USB 2.0 (or later) port on
your computer.
3. Press the power switch on the rear panel of the controller to switch it on.
→ The controller is now detected by the operating system.
2.2 Basic Audio Configuration
In this section, we describe the few steps required to make use of the MASCHINE controller’s
integrated audio interface in various situations: with the MASCHINE software, with other music
software, and within your operating system.
Setting Up MASCHINE
Basic Audio Configuration
MASCHINE - Getting Started - 18
To Next Page
Loading...
