Native Instruments MASCHINE MK3 Getting Started

▪ The Perform Grid setting lets you choose the point at which the playhead has to leave the
current Scene. It can be at the very moment at which you select another Scene, or at a set
interval: on the next eight note, quarter note, etc., or even at the end of the Scene.
▪ The Retrigger allows you to set whether the playhead will start from the point equivalent to
where the playhead leaves the current Scene or from the beginning of the next Scene. The
former (default setting) ensures that the global groove of your track is not interrupted!
9.4.1.1 Jumping to Other Scenes in the MASCHINE Software
In the Arranger, you will find the SYNC menu and the Retrigger check box in the header:
The SYNC and Retrigger controls.
►
To adjust the Scene Sync setting, click the SYNC menu and select the desired entry in
the menu, for example Scene.
→
The next time you select a new Scene or loop range, the switch will happen on the next
Section.
►
To enable/disable the Retrigger setting, click the Retrigger check box from the drop-down
menu.
→
The next time you select a new Scene or loop range, it will start from the beginning.
9.4.1.2 Jumping to Other Scenes using the Controller
To adjust the Perform Grid setting:
1. Press and hold SHIFT + FOLLOW (Grid) to enter Grid mode (or pin it by pressing SHIFT +
FOLLOW (Grid) + Button 1).
Creating Scenes
Playing Live
MASCHINE - Getting Started - 138

Native Instruments MASCHINE MK3 Specifications

General

Brand	Native Instruments
Model	MASCHINE MK3
Category	Recording Equipment
Language	English