5. Click Close to exit the Preferences dialog.
6. Plug your external sound source into the audio input sockets on the rear panel of your
controller: E.g., you could plug a dynamic microphone into the MIC IN socket, or the out-
put of a hardware synthesizer into the LINE IN 1 and 2 sockets.
In the steps above, we assumed that your MASCHINE software is configured for use with
the integrated audio interface available on your MASCHINE MK3 controller (this is the
case by default). Of course, you can follow the same procedure with any other audio in-
terface — just make sure that it is selected in the Device menu of the Audio page in the
Preferences dialog.
Step 2: Make a Sound in your Project listen to your external audio source
1. Now click the Group D in the Arranger to select it.
2. Click the Sound slot 1 in the Pattern Editor to select it.
3. At the far left of the Control area, click the Channel icon (showing a little rotary knob) to
display the Channel properties.
4. Click Input on the left-hand side.
Using Advanced Features
Using Other Sound Sources
MASCHINE - Getting Started - 169
To Next Page
Loading...
