Page 2-16 V10/V7.5/V5/V3.5 Installation and Operation Manual
Issue 3.5 Section 2 Preparation for Use and Installation
2.2.21 Available Options
There are several options available for the
transmitter. Each option is described in
the following paragraphs to assist the user
in selecting the final configuration for the
system.
2.2.21.1 Analog/Hybrid/All-Digital
Option
The transmitter can be configured for
analog (FM), hybrid (FM+HD), or all-digital
(HD) modes. Contact Nautel for more
information on each mode and on issues
with upgrading.
2.2.21.2 Standby Exciter Option
The transmitter can be readily upgraded
to use a standby exciter. When the
standby exciter is installed, set the
transmitter in auto exciter changeover
mode to enable the standby switching
feature.
2.2.21.3 Standby IPA Option
The transmitter can be configured to use a
standby IPA source and an associated
power supply.
For V10/V7.5 transmitters, a standby IPA
module and associated IPA PS module
can be provided.
For V5/V3.5 transmitters, a standby PA,
within the sole IPA module can be
provided. An associated IPA PS module
can also be provided with the standby PA.
When the standby IPA is installed, set the
transmitter in auto IPA (or IPA PA for
V5/V3.5) or IPA PS (V5/V3.5 only)
changeover mode to enable the standby
switching feature.
2.2.21.4 Standby LVPS and Fan Supply
Option
The transmitter can be readily upgraded
to use a standby LVPS and fan supply.
When the standby LVPS and fan supply
are installed, set the transmitter in auto
fan supply (Fan PS) changeover mode to
enable the standby switching feature.
2.2.21.5 Output Connector Option
The V10/V7.5’s standard output
connection is 3-1/8 inch EIA. A 1-5/8 inch
or 7/8 inch EIA output connection is also
available. Use of a 7/8 inch connector is
limited by power level and altitude.
The V5/V3.5’s standard output connection
is 1-5/8 inch EIA. A 3-1/8 inch or 7/8 inch
EIA output connection is also available.
2.2.21.6 Station Spares Kit Option
A comprehensive maintenance spares kit
is available. The kit includes some
surface-mount (SMT) semiconductors and
a quantity of each through-hole
semiconductor, LED, fan, and fuse used
in the equipment, as well as important
repair items.
2.2.21.7 Site Spares Kit Option
An adequate (low level) maintenance
spares kit is available. The kit includes a
limited quantity of fuses used in the
equipment as well as a fan.
2.2.21.8 Ac Power Surge Protector
Panel Option
Nautel can provide an ac power surge
protector panel (Nautel Part # NAX188),
to aid in protecting the transmitter from
lightning. If purchased, refer to the
NAX188 manual for installation details.
2.2.21.9 Closed Ventilation Option
The transmitter can be readily upgraded
to use closed ventilation. Contact Nautel
for information on this option.
2.2.21.10 NxLink Ethernet Interface
Option
The transmitter can be readily operated
with an NxLink module (U15). This
module allows for connection to a LAN
(local area network) for remote control
and monitoring. The user supplies the
Ethernet interface cable. Contact Nautel
for information on this option or refer to
the NxLink Technical Instruction Manual
supplied with the NxLink module.
To Next Page
Loading...
