NAVIS NAVIOR-24S - PASET - Receiver Operation Mode Set

N
AVIOR-24S ™ Appendix D
N
MEA 0183 Communication Interface
199
NAVIOR-24S ™ Revision V1.00 20.05.2008
PASET – Receiver operation mode set
Format:
$PASET, m, tttt, ddmm.mmmm, N, dddmm.mmmm, E, aaaa.a <CR><LF>
Field Format
m receiver operation mode:
“0”- navigation
“1”- with known antenna position (time solution)
“2”- average, - based on statistical processing of antenna coordinates
tttt quantity of average processing steps in minutes (max value is 1440 = 24
hour)
ddmm.mmmm,N antenna installation latitude (N/S) in WGS-84
dddmm.mmmm,E antenna installation longitude (E/W) in WGS-84
aaaa,a antenna installation altitude in WGS-84
<CR><LF> 2 ASCII control characters
This message is used to set receiver operation mode