NAVIS NAVIOR-24S - Appendix A Navis Standard Interface Protocol BINR; Interface Scope

N
AVIOR-24S ™ Appendix A
N
avis Standard Interface Protocol BINR
68
NAVIOR-24S ™ Revision V1.00 20.05.2008
A. Navis Standard Interface Protocol BINR
Interface Scope
The NAVIS standard Interface Protocol BINR provides the customers and system designer with
possibilities to configure a GNSS navigation receiver for optimum performance in a variety of
applications.
The BINR protocol is used especially in the NAVIS navigation receivers. This protocol is based on
the transmission of packets of information between the user equipment and the unit. Each packet
includes an identification code (1 byte, representing 2 hexadecimal digits) that identifies the
meaning and format of the data that follows. Each packet begins and ends with control characters.
This Appendix describes in detail the format of the transmitted data, the packet identification codes,
and all available information over the output channel to allow the user to choose the data required
for his particular application.