NAVIS NAVIOR-24S - Programmable Characteristics - Signal Offset (Cable Delay Compensation)

N
AVIOR-24S ™ CHAPTER IV
Operation and Performance
66
NAVIOR-24S ™ Revision V1.00 20.05.2008
Programmable Characteristics - Signal Offset (Cable Delay Compensation)
The receiver firmware also enables the user to offset the delay of the PPS pulse with
reference to the actual PPS second tick. This delay is the result of antenna cable length and
propagation delay of the PPS output signal. The delay compensation parameter can be set (in
nanoseconds) using BINR packet (D7h). Note that the current firmware version only allows the
update of the PPS offset parameter of the PPS definition packet (D7h).
Note – Navis has measured less than 50 nanoseconds accuracy of the NAVIOR-24S GPS/GLONASS
receiver PPS signal in static mode. For more information on timing applications, contact your
Navis sales representative.