NAVIS NAVIOR-24S - Serial Interface

N
AVIOR-24S ™ CHAPTER II
Hardware Integration
37
NAVIOR-24S ™ Revision V1.00 20.05.2008
Serial Interface
As an embedded design, the NAVIOR-24S GPS/GLONASS module provides direct CMOS
compatible TTL level serial I/O. The RX and TX signals on the X501 I/O connector are driven
directly by the UART on the NAVIOR-24S GPS/GLONASS receiver. Interfacing these signals
directly to a UART in your application circuitry provides direct serial communication without the
complication of RS-232 or RS-422 line drivers.
Note – The serial I/O signals on X501 are CMOS level.