Service Level Troubleshooting 3-86
The command/status sequence is completely the same for Mode1 and Mode2. The only
difference is the printing speed.
• Mode1—maximum of 12 ips (the same as the normal printing)
• Mode2—maximum of 4 ips (to prevent the clatter print in the synchronized line
mode)
When Mode3 is selected, the following command will be available:
When Receipt Synchronization is disabled, the printer returns the status for buffered
status command immediately after decoding the status command.
The Receipt Synchronization allows for increased print speed or provides the ability to
check for the completion of each print line. When the Receipt Synchronization is enabled
the highest print speed is achieved but the verification that the print line has been
successfully completed occurs every 10 print lines.
Caution: Be extremely careful in changing any of the printer settings. This is to avoid
inadvertently changing other settings that might affect the performance of the printer.
• To select a receipt synchronization, press the Paper Feed button.
Save parameters
This function allows to save the selected communication settings or return to the
communication settings to select additional options.
Press the Paper Feed button for the option you want.
To Next Page
Loading...