NCR 7169 - Obtaining IP Address Automatically; TCP;UDP Setting

Configuration Network 7-144
Obtaining IP address automatically
When DHCP is enabled, the printer automatically gets the IPaddress, the Subnet Mask,
and the Default Gateway from a DHCP server. If the printer does not automatically get
the IPaddress, it uses the same IPaddress as the Manual mode. The DHCP allocated IP
address can be seen on the Diagnostics Form of the connected printer.
TCP/UDPsetting
Items
Default
Value
Detail
Number of
TCP
Connections
1 Specifies the maximum number of hosts that can be
connected. The maximum number of hosts that can be
connected is 6.
Time of Time-
out (for Link
Down)
120min Specifies the Link Down time-out. The maximum Link
Down time-out is 120 minutes. When the value is set to
zero, time–out is disabled.
Time of Time–
out (for Idle)
2 min Specifies the Idle time-out. The maximum Idle time-out is
120 minutes. When the value is set to zero, time-out
disabled.
Real Time
Command
TCP Protocol options for Real Time command. The following
options in the drop-down list are:
• TCP
• UDP
TCPport 9100 Specifies the TCPRAW port number. The TCP port
number ranges from 1024 to 65535.
When "Real Time Command" setting isTCP, it is used by
sending and receiving of Real Time Command.
UDPport 3000 Specifies the UDP port number. The UDP port number
ranges from 1024 to 65535.
This is effective when "Real Time Command" setting is
UDP.