6-134 Reflashing the Printer Firmware
It is very rare for the Single Byte Font to have to be updated. Since there is only enough
memory in the printer for one of the Two Byte Fonts to be loaded at any time, the Two
Byte Font will typically need to be loaded prior to installation in the appropriate
country.
Note: The Font files, both Single and Two byte, should be loaded into the printer after
the Boot and Main firmware have been loaded.
Printer languages cross-reference
Font Type Print Station File Name
ANK Receipt 7169_SBCS_V2101.sfn*
Arabic Font Receipt
Japanese CP932 Receipt 7169_DBCS_V2201.sfn*
Korean CP949 Receipt
Simple Chinese CP936 Receipt
Traditional Chinese CP950 Receipt
The following items need to be noted:
• The noted font files are included on LPIN A370-0050-0000 or are available from the
NCR web site under Retail Solution Specific Printer Firmware.
• The asterisk (*) denotes that the printer is preloaded with these fonts from the
factory.
• When Asian fonts are to be used, select the appropriate Asian Code Page in the
diagnostic set and also enable the Asian Mode.
• The above file names are latest as of 10
th
Jan 2017. Based on the new modification,
the filenames may change.
• 7169_SBCS_V2101.sfn is inclusive of ANKand Arabic Font.
• 7169_DBCS_V2201.dfn is inclusive of Japanese CP932, Korean CP949, Simple
Chinese CP936, and Traditional Chinese CP950.
To Next Page
Loading...